În general, costul achiziționării unui compresor de aer pentru utilizare include două părți: costul de cumpărare și costul de întreținere, care reprezintă 20% din costul total; Cea Există mai multe motive principale pentru acest .
1. When the air compressor is running, using the appropriate voltage for operation can result in a significant waste of energy due to asymmetric power supply voltage or excessively high or low voltage. Due to the imbalance of single-phase loads in the three-phase four wire low-voltage power supply system, the three-phase voltage of the motor is asymmetric, causing the motor to generate cuplu de secvență negativă, creșterea asimetriei tensiunii trifazate a motorului, determinând motorul să genereze cuplu de secvență negativă și creșterea pierderilor în timpul funcționării motorului . În plus, tensiunea scăzută pe termen lung a rețelei electrice determină ca curentul motorului să fie mai mare în timpul funcționării normale, rezultând pierderi crescute {{9} # scădeți tensiunea și cu cât pierderile sunt mai mari .
2. Întreținerea și gestionarea slabă a compresoarelor de aer necesită întreținere regulată după o anumită perioadă de funcționare . dacă există abateri ale componentelor, repararea sau înlocuirea în timp util este necesară . Dacă motorul și echipamentul nu sunt reparate și menținute, după cum este necesar, și lăsate să funcționeze mult timp, nu va fi doar eficiența scăzută, dar și va continua să funcționeze pentru o perioadă lungă crește .
3. The motor load rate of the air compressor is low, which may be due to improper selection of the motor, excessive surplus or changes in production process, resulting in the actual working load of the motor being much lower than the rated load. The motor, which accounts for about 30% to 40% of the installed capacity, operates at 30% to 50% of the rated load, resulting in low operating efficiency but no reduction in consumul de energie, ceea ce duce la o cantitate mare de deșeuri de energie .
4. Outdated and old motors are still in use. The manufacturing process of these motors is relatively rough, but the technology is not as advanced as it is now. They use E-grade insulation, which results in large volume, poor starting performance, low efficiency, and energy consumption. The working efficiency is not proportional to the cost, which is also one of the reasons Pentru consumul grav de energie al compresoarelor de aer .
